Directed Electronics Remote Start Manual

The Directed Electronics Remote Start system provides convenient vehicle starting from a distance, featuring keyless entry, security functions, and temperature-controlled activation. Compatible with most modern vehicles, this system includes remote transmitters, control module, antenna, and all necessary installation components. Below are key sections for safety, features, installation, programming, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. Programming & Setup 4. Specifications 5. Remote Controls 6. System Operation 7. Security Features 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Remote transmitters, Control Module, Antenna, LED Status Indicator, Valet Switch, Wiring Harness.

Feature	Description
Remote Start	Start vehicle from up to 1000 feet away
Keyless Entry	Lock/unlock doors remotely
Security System	Shock sensor, door trigger protection
Temperature Control	Auto-start based on cabin temperature
Runtime Management	Programmable run time (5-60 minutes)
Valet Mode	Temporarily disable remote start
LED Indicator	System status and alarm notifications
Panic Mode	Activate alarm from remote
Trunk Release	Remote trunk opening (if equipped)
Turbo Timer	Cool-down period for turbocharged vehicles

Installation

Professional installation recommended. Unpack and inspect all components.

Locate control module: Mount in dry, secure location under dashboard.
Connect wiring harness: Match vehicle wiring to system connectors.
Install antenna: Place for optimal signal reception.
Mount LED indicator: Visible location on dashboard.
Connect valet switch: Accessible but concealed location.
Test all functions before final assembly.

WARNING! Disconnect vehicle battery before installation. Improper installation may damage vehicle electronics.

Programming & Setup

Program system after installation completion.

Enter programming mode: Turn ignition ON/OFF three times.
Program remotes: Press buttons in sequence as indicated by LED flashes.
Set runtime: Default 15 minutes, adjustable via programming.
Configure temperature settings: Set desired auto-start temperature range.
Program door locks: Match vehicle's lock/unlock timing.
Test all programmed features.

CAUTION! Ensure vehicle is in park with parking brake engaged during programming.

Specifications

Operating Range: Up to 1000 feet line-of-sight.
Frequency: 315MHz or 434MHz (model dependent).
Battery Life: 12 months typical remote battery life.
Runtime Options: 5, 10, 15, 30, 45, 60 minutes.
Temperature Range: -40°F to 185°F operating temperature.
Compatibility: Most gasoline vehicles 1996 and newer.
Security: Rolling code technology.
Warranty: 1-year limited warranty.

Remote Controls

Primary remote: LOCK, UNLOCK, REMOTE START, PANIC, TRUNK. Secondary remote: Basic functions.

Button Functions: LOCK (arms security), UNLOCK (disarms), REMOTE START (hold 2 seconds), PANIC (emergency alarm), TRUNK (hold 2 seconds).

LED Indicators: Green flash (command accepted), Red flash (system armed), Rapid flash (alarm triggered). Range: Up to 1000 feet unobstructed.

System Operation

Remote Start: Press and hold REMOTE START for 2 seconds. Vehicle starts, runs for programmed time.

Ensure vehicle is in park with parking brake set.
Press and hold REMOTE START button.
Release when parking lights flash.
Vehicle starts automatically.
To enter vehicle: Press UNLOCK, system disarms.
To drive: Insert key, turn to ON position.

Tip: System will not operate if hood is open, brake is pressed, or security is triggered.

Security Features

Shock Sensor: Detects impacts to vehicle. Door Triggers: Monitors all doors. LED Indicator: Shows system status.

Arming: Automatic 30 seconds after doors close or manual with LOCK button. Disarming: UNLOCK button or key in ignition. Panic Mode: Hold PANIC button for 3 seconds.

Maintenance

Check remote batteries annually. Keep system dry and clean. Test functionality monthly.

CAUTION! Do not expose control module to moisture. Have system inspected by professional if issues arise.

Regulatory Information

FCC Part 15: This device complies with part 15 of FCC rules. Operation subject to conditions: (1) device may not cause harmful interference, (2) device must accept any interference received. IC: Complies with Industry Canada license-exempt RSS standard(s). Copyright © Directed Electronics. For support, visit www.directed.com or contact 1-800-876-0800.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Remote not working	Dead batteries/range	Replace batteries; move closer to vehicle.
Vehicle won't start remotely	Safety features active	Check hood/doors closed; parking brake set.
System beeps repeatedly	Security triggered	Check doors/windows; disarm with UNLOCK.
Reduced range	Battery/low interference	Replace remote batteries; check for interference sources.
Doors not locking	Programming/connection	Reprogram door locks; check wiring connections.

Reset: Disconnect battery for 30 seconds to reset system.

Service: 1-800-876-0800; www.directed.com