DIRECTV Universal Remote Control RC32 Manual

The DIRECTV RC32 Universal Remote Control is a versatile infrared remote designed to control multiple devices including DIRECTV receivers, TVs, DVD players, and audio systems. Features include device selection buttons, numeric keypad, navigation controls, volume and channel controls, menu access, and programmable functions for universal compatibility. Below are key sections for setup, programming, operation, and troubleshooting.

1. Features at a Glance 2. Package Contents 3. Remote Control Layout 4. Battery Installation 5. Programming the Remote 6. Controlling Multiple Devices 7. Special Functions 8. Troubleshooting 9. Specifications

Features at a Glance

Key components: Device selection buttons, LCD display (if applicable), IR transmitter, battery compartment.

FeatureDescription
Device SelectionTV, DVD, AUDIO, DIRECTV receiver controls
Numeric KeypadFor direct channel/input selection
Navigation ControlsArrow keys and SELECT/OK button
Volume/Channel ControlsDedicated buttons for audio and channel adjustment
Menu AccessMENU, INFO, EXIT, GUIDE buttons
Universal ProgrammingCan be programmed for multiple brands and devices
Power ControlSeparate power buttons for each device
Battery IndicatorLow battery warning (if applicable)

Package Contents

NOTE: Batteries may be sold separately in some regions.

Remote Control Layout

Front panel layout with button descriptions:

  1. Top Section: Power buttons for each device (TV, DVD, AUDIO, SAT)
  2. Device Selection: TV, DVD, AUDIO, SAT buttons to switch control modes
  3. Numeric Keypad: 0-9 buttons for direct input
  4. Navigation Cluster: Up/Down/Left/Right arrows with SELECT center button
  5. Function Buttons: MENU, INFO, EXIT, GUIDE, DASH (-)
  6. Volume/Channel: VOL +/-, CH +/-, MUTE
  7. Playback Controls: PLAY, PAUSE, STOP, FF, REW, RECORD (if applicable)

Battery Installation

Install batteries for remote operation:

  1. Turn remote over and locate battery compartment
  2. Slide cover open in direction of arrow
  3. Insert 2 AA batteries, observing correct polarity (+/-)
  4. Replace battery cover securely

WARNING! Use only fresh batteries of the same type. Do not mix old and new batteries.

Programming the Remote

Program remote to control your devices:

  1. Turn on the device you want to program (TV, DVD, etc.)
  2. Press and hold the corresponding device button (TV, DVD, AUDIO) until all mode lights blink twice
  3. Enter the 5-digit code for your device brand using numeric keypad
  4. Press POWER button to test - device should turn off if code is correct
  5. If device doesn't respond, repeat steps with another code for your brand

Tip: Refer to code list in manual or visit DIRECTV website for manufacturer codes.

Controlling Multiple Devices

Switch between devices using mode buttons:

NOTE: The remote remembers settings for each device separately.

Special Functions

Advanced remote features:

FunctionDescription
Volume LockLets you control volume through receiver instead of TV
Input SelectSwitch between TV input sources (AUX, HDMI, etc.)
Favorite ChannelsProgram frequently watched channels for quick access
Parental ControlsAccess parental lock features through menu system
Reset FunctionHold MENU and SELECT simultaneously for 5 seconds to reset

Troubleshooting

SymptomPossible CauseCorrective Action
Remote not workingDead batteries/obstructionsReplace batteries; ensure clear path to device
Controls wrong deviceIncorrect programmingReprogram with correct manufacturer code
Some buttons not workingDevice compatibilityTry alternate codes; some functions may not be supported
Intermittent operationWeak batteries/distanceReplace batteries; move closer to device
No response from deviceWrong mode selectedPress correct device button (TV, DVD, AUDIO, SAT)

Specifications

Support: For additional help, visit www.directv.com/remote or call 1-800-531-5000

DIRECTV Universal Remote Control RC32 Manual © - All Rights Reserved 2025